Most of the time, companies will spend a lot of money to purchase their lift trucks. It is vital, therefore to take good care of your machine to protect your investment into the long run. It is a good idea to know the procedures which are carried out during the maintenance and care of this piece of equipment.
By starting up the forklift and listening closely how it runs is amongst the best ways to tell how good the engine is working. Like for instance, if there are any knocks or misses, the machinery is faulty and this should raise several concerns. Also listen closely for any squealing sounds which come from the belts as these noises would provide you with a wealth of information.
Several of the main parts needing attention during maintenance include the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty parts have to be replaced as soon as they are noticed. It is also vital to check the wiring.
After the above parts have been inspected carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each battery cell needs to be inspected so as to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters have to be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be carried out. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Next, check each and every other part of the machine including the wheels. If any type of fault or concern is detected, be sure to address it immediately in order to make sure the equipment is running at its safest and optimum levels.